Kia Cadenza YG: Body (Interior and Exterior) / Body Dimensions
- General Information
- Front Body Body Repair
- Side Body Body Repair
- Interior Body Repair
- Rear Body Body Repair
- Under Body Body Repair
Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panoramaroofDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panoramaroofLoose or deformed deflector, gaps in body workRetighten adjust or replaceNoise heard when opening.
General 1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body Electrical System
- Front Bumper Repair procedures
- General Information
- New on site
- Most important about car
