Kia Cadenza YG: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
C.T
0.5
4.5
W.O.T
4.41
0.59

ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the air intake hose.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the ETC module connector (A).
4.
Disconnect the coolant hoses (B).
5.
Remove the installation bolts, and then remove the ETC module (C) from the engine.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at th IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
   
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.

    Circuit Diagram

    Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assemby. It senses absolute pressure of the air cleaner assemby and transfers the analog signal proportional to the pressure to the ECM.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location

    C

    Kia Cadenza YG 2016-2021 Service Manual: Description and Operation

    Description System Operation Typically, lane departure warning is activated at a speed over 70 KPH, but suppressed in case of unintentional lane departure when driver do not operate turn signal. System Operation Conditions 1. User Conditions (1) When unintended lane departure is occured, warnings are generated.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0304