Kia Cadenza YG: Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation
| Description |
Purge Control Solenoid Valve (PCSV) is installed on the surge
tank and controls the passage between the canister and the intake
manifold. It is a solenoid valve and is open when the ECM grounds the
valve control line. When the passage is open (PCSV ON), fuel vapor
stored in the canister is transferred to the intake manifold.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2.
Specification ItemSpecificationCoil Resistance (Ω)22.0 ~ 26.0 [20°C(68°F)]
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Description and Operation
D
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Schematic Diagrams
- Battery Troubleshooting
- Steering System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0248