Kia Cadenza YG: Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Description and Operation

Description
•
SS-B solenoid valve is ON/OFF type.
•
When TCM supplies power to solenoid valve, speed range is changed by operating the solenoid valve.

SS-B Solenoid Valve operation table
　
SS-B
N, P

1

2

3
●
4
　
5
●
6
　
R
●

● : Connected status
Δ : Connected at vehicle speed above 8km/h

    Component Location 1. SS-B Solenoid Valve (ON/OFF)

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0277