Kia Cadenza YG: Blind Spot Detection System / Blind Spot Detection Unit Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
3.
Remove the BSD unit (A) after loosening the mounting screws.

   
Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Installation
1.
Install the BSD units to the rear bumper.
2.
Install the rear bumper.
3.
Connect the negative (-) battery terminal.
   
Take care not to confuse left side (slave) and right side (master) unit when installing.
Item
Left (Slave)
Right (Master)
Shape


Remarks
Check the mounting screw hole shape

    Circuit Diagram

    Description The used radar frequency of BSD is two, "North America region" and "Except North America region". If it replaces BSD unit, BSD unit has to perform the procedure of variant coding.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Pantoscopic Camera Components and Components Location

    C

    Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0278