Kia Cadenza YG: Engine Mechanical System / Cylinder Head Assembly
- Components and Components Location
- Valve Clearance Adjustment
- Cylinder Head Cover Repair procedures
- CVVT & Camshaft Components and Components Location
- CVVT & Camshaft Description and Operation
- CVVT & Camshaft Repair procedures
- Cylinder Head Components and Components Location
- Cylinder Head Repair procedures
Removal 1. Set No.1 cylinder to TDC/compression. (1) Turn the crankshaft pulley clockwise and align its groove with the timing mark "T" of the lower timing chain cover.
Components 1. RH Cylinder head2. RH Cylinder head gasket3. LH Cylinder head4. LH Cylinder head gasket5. Cylinder block 1. Camshaft bearing cap 2.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Driveshaft and axle
- Emission Control System
- Suspension System
- New on site
- Most important about car
