Kia Cadenza YG: Engine And Transmission Assembly / Engine Room Under Cover Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Repair procedures

Removal and Installation
1.
Remove the engine room front under cover (A) and the side covers (B).

   
When removing the under covers (B), unfasten the mounting bracket bolts and then remove the under cover and mounting bracket assembly.
2.
Install in the reverse order of removal.

    Components 1. Engine room front under cover2. Engine room RH side cover3. Engine room LH side cover

    Components 1. Transaxle mounting bracket2. Roll rod bracket3. Sub frame4. Engine mounting bracket5. Engine mounting support bracket

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Ambient Sensor Repair procedures

    Inspection 1. Ignition "OFF" 2. Disconnect ambient temperature sensor. 3. Check the resistance of ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature. 1. Sensor Ground2.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0236