Kia Cadenza YG: Suspension System / Front Suspension System
- Components and Components Location
- Front Strut Assembly Components and Components Location
- Front Strut Assembly Repair procedures
- Front Lower Arm Repair procedures
- Front Stabilizer Bar Repair procedures
- Front Cross Member Repair procedures
Troubleshooting Vehicle inspection SYMPTOM CHART SymptomSuspect AreaRemedy (See page)Squeak or grunt-noise from the front suspension, occurs more in cold ambient temperatures-more noticeable over rough roads or when turningFront stabilizer barUnder these conditions, the noise is acceptable.
Components 1. Sub frame2. Lower arm3. Front axle4. Drive shaft5. Steering gear box6. Front stabilizer bar7. Front strut assembly
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Mechanical System
- Schematic Diagrams
- Steering System
- New on site
- Most important about car
