Kia Cadenza YG: Body (Interior and Exterior) / Interior
- Console Components and Components Location
- Console Repair procedures
- Crash Pad Components and Components Location
- Crash Pad Repair procedures
- Roof Trim Components and Components Location
- Roof Trim Repair procedures
- Interior Trim Components and Components Location
- Interior Trim Repair procedures
- Trunk Trim Repair procedures
- Windshield Glass Components and Components Location
- Windshield Glass Repair procedures
- Rear Window Glass Repair procedures
Replacement 1. Remove the cover (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.
Components 1. Gear knob & boots 2. Floor console upper cover3. Floor console upper cover tray4. Console side cover [LH]5. Console side cover [RH]6.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Description and Operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Schematic Diagrams
- Engine Control / Fuel System
- Components and Components Location
- New on site
- Most important about car
