Kia Cadenza YG: Restraint / SRSCM
- SRS Control Module (SRSCM) Description and Operation
- SRS Control Module (SRSCM) Components and Components Location
- SRS Control Module (SRSCM) Repair procedures
- Front Impact Sensor (FIS) Description and Operation
- Front Impact Sensor (FIS) Components and Components Location
- Front Impact Sensor (FIS) Repair procedures
- Side Impact Sensor (SIS) Description and Operation
- Side Impact Sensor (SIS) Components and Components Location
- Side Impact Sensor (SIS) Repair procedures
- Seat Belt Buckle Switch (BS) Description and Operation
- Seat Belt Buckle Switch (BS) Components and Components Location
- Seat Belt Buckle Switch (BS) Repair procedures
- Occupant Detection System (ODS) Description and Operation
- Occupant Detection System (ODS) Components and Components Location
- Occupant Detection System (ODS) Repair procedures
- Schematic Diagrams
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries.
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Description and Operation
D
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Engine Electrical System
- Battery Troubleshooting
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0287