Kia Cadenza YG: Driveshaft and axle
- Specifications
- Special Service Tools
- Troubleshooting
- Front Axle Assembly
- Driveshaft Assembly
- Rear Axle Assembly
Removal 1. Remove the center console assembly. (Refer to Body - "Console") 2. Remove the duct (A). 3. Remove the control cable (B). 4.
Specification Engine & T/MJoint typeMax. permissible angleInnerOuterInnerOuterLambda 3.3 GDIVTJ#25BJ#2621°46.5° Tightening Torques ItemN.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body Control Module (BCM) Description and Operation
- Body (Interior and Exterior)
- Restraint
- New on site
- Most important about car
