Kia Cadenza YG: Brake System / ESC(Electronic Stability Control) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- EBD(Electronic Brake-force Distribution) Description and Operation
- ESC Control Module Components and Components Location
- ESC Control Module Repair procedures
- Front Wheel Speed Sensor Components and Components Location
- Front Wheel Speed Sensor Repair procedures
- Rear Wheel Speed Sensor Components and Components Location
- Rear Wheel Speed Sensor Repair procedures
- Yaw-rate and G Sensor Description and Operation
- Yaw-rate and G Sensor Repair procedures
- ESC OFF Switch Description and Operation
- ESC OFF Switch Repair procedures
- Steering Angle Sensor Description and Operation
Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3.
Components 1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral G sensor5. Steering angle sensor6. ABS Warning lamp7.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Troubleshooting
Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Engine Mechanical System
- Restraint
- New on site
- Most important about car
