Kia Cadenza YG: Brake System / ESC(Electronic Stability Control) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- EBD(Electronic Brake-force Distribution) Description and Operation
- ESC Control Module Components and Components Location
- ESC Control Module Repair procedures
- Front Wheel Speed Sensor Components and Components Location
- Front Wheel Speed Sensor Repair procedures
- Rear Wheel Speed Sensor Components and Components Location
- Rear Wheel Speed Sensor Repair procedures
- Yaw-rate and G Sensor Description and Operation
- Yaw-rate and G Sensor Repair procedures
- ESC OFF Switch Description and Operation
- ESC OFF Switch Repair procedures
- Steering Angle Sensor Description and Operation
Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3.
Components 1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral G sensor5. Steering angle sensor6. ABS Warning lamp7.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
Component Location 1. Start Stop Button(SSB)2. FOB key3. RF receiver4. Smart key unit5. Interior antenna 16. Interior antenna 2 7. Trunk antenna8. Bumper antenna9. Door handle & door antenna10. Trunk lid open switch11.
Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Emission Control System
- Engine Electrical System
- Components and Components Location
- New on site
- Most important about car
